22284 Autoloader 2 ALE2: System pressure out of tollerance. Please run cal pressure Trendsetter_VLF_Auto This may be reported as a warning or an error. If either main or picker pressure is read more than 1.7 psi above or below the design pressure, this will suspend with an error. When it detects the pressure too high, then it attempts to lower the pressure by bleeding some air out of the table cups. If this fixes the problem then only a warning is displayed, but it should be a heads up to visit the site and run cal pressure before it goes hard down. If only one sensor is reading wrong, it may be caused by the sensor. Check cal pressure flow. Resume if possible, otherwise call Creo Response Center. Check that inlet pressure is above 90 psi Either main or picker pressure is more than 1.7 psi above or below the design pressure. ../commands/cal_pressure.xmlCommand: cal pressure ../commands/ale.xmlCommand: ale ../commands/picker.xmlCommand: picker ../nvs/al_cfg_ppsc.xmlNVS: al ppsc ../nvs/al_cfg_mpsc.xmlNVS: al mpsc ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:34:03 2008 PST